WE-12 Water Eliminator – Length: 12″ – Diameter: 1.85″ (AA0872)
WE-12 Water Eliminator Contains Crystals that Absorb Water From Diesel Fuel, Fuel Oil, Kerosene or Hydraulic Fluid
WE-12 Water Eliminator with two Lanyards
Purchase 5 or more WE-12 Water Eliminators and Save $1.00 Off Each One!
The Water Eliminator captures water directly from the fuel or oil in the tank. The crystals contained inside the Water Eliminator are water specific and will swell encapsulating the water until the cartridge is full. Water specific means they will only absorb the water in your fuel tank. These crystals will not absorb or adversely affect gasoline, diesel fuel, fuel oil, JP5 or hydraulic oil.
If you store gasoline or diesel fuel for use in equipment, operate a boat, RV, backup power generators, farming or construction equipment, you need the Water Eliminator. The WE-12 is the most cost effective way to remove water from Gasoline, Diesel Fuel, Fuel Oil, Kerosene or Hydraulic Fluid.
The Water Eliminator presents an easy and economical solution for removing water from tanks used to store fuel. It may be installed in equipment tanks, fuel stored in day tanks to meet surge demand, or larger storage tanks. Maintaining fuel free from water reduces the potential for microbial contamination and accumulation of sludge in tanks.
When used in mobile equipment, check your Water Eliminator at each fuel stop. If the unit is empty, your tank is water free. Leave it in place until nearly full, then discard in a proper receptacle and replace it with a new one. (Disposal in accordance with local and federal regulations.)
It helps prevent problems caused by water contamination in fuel tanks including:
- Plugged Fuel Filters
- Fuel-line Freeze-up
- Damaged Fuel Pumps & Injectors
- Growth of Microbial Contamination
- Loss of Power
- Down Time
Two 39 inch (1 meter) lanyards with snap hooks on one end and a loop on the other are included with each WE-12 Water Eliminator. Attach one end of a lanyard to the WE-12, and the other inside the fuel cap or similar easy to reach location. Connect lanyards for deep tanks. Any number of Water Eliminators may be “daisy chained” together for large tanks. A metal rod is included in each Water Eliminator to assure it sets on the bottom of the fuel tank. A fill cap opening of 1.85 inches (4.7 cm) is required.
One (1) 12 inch long Water Eliminator and two lanyards are in each package.